Ampeg SVP Pro (black face, 1995 board, new tubes in 2013, about 90 hours run since)
Carvin HD 2000 power amp (Specs: http://carvinimages.com/documents/power ... manual.pdf)
Furman PL-8 Power conditioner / light module
SKB 4U Roto rack case
Rear panel PowerCon in/switched-out, ch1-ch2 (amp in parallel mode, can be rewired in bridged), DI out from SVP, two 1/4" locking - not connected (originally for effects loop)
Comes with PowerCon cords for in and out (not pictured, 6' in - black, 20' out - yellow) and 6' 12ga speakon-speakon cable.
$400
Carvin B410-4 4x10 4ohm cab.
$150
$450 for all. Altoona/State College area, can demo in State College.
http://imgur.com/a/TPVn3
FS: Ampeg SVP Pro based bass rig
-
JackANSI
- Diamond Member
- Posts: 1322
- Joined: Friday May 16, 2008
- Location: Workin' in a Soylent factory, Waitin' for the Malthusian catastrophe.
FS: Ampeg SVP Pro based bass rig
Last edited by JackANSI on Tuesday Oct 25, 2016, edited 3 times in total.