can anyone tell me

LIMB BY LIMB · Post by **LIMB BY LIMB** » Tuesday Jan 10, 2012

I have a 6x10 cab with all 8ohm speakers that is currently 4 ohm cab...does anyone know where I can get a diagram to make it 8 ohm

Craven Sound · Post by **Craven Sound** » Wednesday Jan 11, 2012

It sounds like you might want a mix of series and parallel wiring, but with six speakers it's unlikely you'll get 4 ohms unless you bypass two speakers.

Craven Sound · Post by **Craven Sound** » Wednesday Jan 11, 2012

Here is a handy diagram:

http://www.allaboutcircuits.com/vol_1/chpt_5/6.html

onegunguitar · Post by **onegunguitar** » Wednesday Jan 11, 2012

Hello lonewolf........................

lonewolf · Post by **lonewolf** » Wednesday Jan 11, 2012

Thats actually a 5.3 ohm cab. Close enough for rock & roll. The only option is to make it a 12 ohm cab.

That can be done by wiring two groups of 3 speakers in series and then wiring the groups in parallel.

You can also wire 3 groups of two speakers in parallel and then wire the groups in series.

I like the 1st one better.

LIMB BY LIMB · Post by **LIMB BY LIMB** » Wednesday Jan 11, 2012

yeah lonewolf pm'd me yesterday and got me fixed up... Thanks again!!