EMG PJ Set - Make your bass a punchy beast!!!

[MOONDOGGY]

I have an EMG PJ Set that was in a bass that I no longer have. And I don't have any other basses w/ PJ setups to put this in. It was used probably about 10 hours. These are newer EMGs w/ connectors on the pickups.

This comes with the following:

- Precision p/up
- Jazz p/up
- battery clip
- 2 volume pots (can be made into vol/blend setup)
- tone pot w/ circuit board


More details found here:

http://www.emgpickups.com/products/category/24/2


The pots are already wired together. All you need to do is solder the p/up leads to the circuit board and leads to the output jack. I do not have the mounting foam, pickup screws, jack, or knobs, but if you're retrofitting your PJ bass, you shouldn't need these things! These run $160 new.


I'm looking for $90.

Pics available soon if you need them.

[MOONDOGGY]

$80???


That's still about $20 cheaper than just the EMG P pickup new, so even if you don't use the J, you're still saving money.

[MOONDOGGY]

SOLD